Instruction manual

INSTALLATION OF INK SHEET

Paper

INSTALLING THE INK SHEET

Load the ink cassette with the ink sheet roll before inserting the ink cassette into the

printer.

Put the ink sheet rollers with flat tops into the holes of ink

cassette.

Put the white roller (rolled with ink sheet) to the ink cassette first.

Then, put the colored roller (without ink sheet) to the ink cassette.

Put the other sides of rollers. Set IC at this time.

IC chip with the IC holder is attached to the ink sheet.

Set the IC holder to the ink cassette as shown right.

NOTE

• Do not remove the IC chip or IC holder from the ink sheet. Removal of the IC

will stop the printer from functioning correctly.

• Set the projected part of the IC holder to the correct position as shown below.

Remove the seal, and insert the edge of the print paper right

below the roller cover with arrow marks towards the front panel.

Make sure to insert the paper straight.

Feed the print paper through the paper outlet with your hand.

Pull the both side of the print paper to eliminate slack.

BEFORE OPERATION

Projected part

arrow marks

colored roller white roller

IC holder