User Manual

12
OTHERSPRECAUTIONS FEATURES
PREPARATION
TROUBLE-
SHOOTING
CONTENTS
After the POWER indicator’s color has changed from orange to
green, press the OPEN button to release the printing unit out.
Remove the paper strip bin and then pull the knob to open the
door.
Install the print paper into the unit.
Place the printing paper in the correct orientation.
Make sure the paper roll is rmly installed.
• Do not push down on the printing unit or the door.
If you push down on the printing unit or the door when they are open, this
unit may fall and it can cause damage or injury.
CAUTION
• Make sure to turn on the power before installing the
print paper. Otherwise, a paper jam may occur.
• Load the paper roll slowly into the unit. If it is
dropped along the ditches, the unit or accessories
may be damaged.
NOTE
Remove the sticker and insert the print paper between the roller
and guide as shown right to feed it. When the buzzer sounds,
stop the paper feeding.
Remove the sticker before inserting the print paper between roller and guide. Make
sure to insert the paper straight.
Buzzer continues to sound until the printing unit is closed.
• Keep the rollers clean. Dirt on the rollers may produce poor print quality.
NOTE
• When taking the print paper out, pull it up toward you by holding the
paper anges.
• Make sure to turn on the power before replacing the print paper.
• Make sure to eliminate any slack from the print paper. If you carry out
the following steps without eliminating the slack, the print paper may be
damaged.
NOTE
• If you continue to feed the print paper inward after the buzzer sounds, it
may cause a paper jam.
NOTE
Close the door.
OPEN button
Knob
Direction of paper insertion
Roller
Print paper
Guide
BEFORE OPERATION