User Manual

11
OTHERSPRECAUTIONS FEATURES
PREPARATION
TROUBLE-
SHOOTING
CONTENTS
PRINT PAPER INSTALLATION
Spacers
See the Quick Setup Guide on how to use the spacers.
How to attach the spacers
1. Insert the spacer with the paper ange’s stoppers retracted.
2. Turn the spacer until the latches are locked.
When you remove the spacers from the paper anges, follow the above
procedure in reverse.
Spacer
Latch
Paper
ange
BEFORE OPERATION
Attach the supplied paper anges to both sides of the print
paper.
When you pinch the latches on the paper ange, the stoppers retract into the shaft.
Attach the anges to the print paper with the stoppers retracted.
Make sure that the anges are attached to the print paper securely, and release the
latches.
• Take care not to pinch your ngers.
• Do not remove the sticker on the print paper roll yet.
• Do not loosen the paper roll. Any slack in the print paper may degrade
the print quality.
NOTE
• When placing the print paper, keep the print paper upright.
• When you put the print paper sideways, it may roll and fall. This may
cause injury.
CAUTION
INCORRECT
CORRECT
• Fingerprints or dust on the paper’s surface may degrade print quality and
cause paper jams.
NOTE
• When the paper ange cannot be attached due to the deformation of the
print paper, reshape the print paper manually before attaching the ange.
NOTE
Press the POWER switch on the right side panel to turn on the
power.
Sticker
POWER switch