Installation Manual

2. Insert rubber grommets into 1” holes located on enclosure back.

3. Enclosure back (item #1) will mount to structure by piercing rubber

grommets. Install two fasteners on right side, back out enough to slide box

mounting tabs under fastener and retighten, then install two additional fasteners

to the left side.

If mounting to masonry surface you can pre-mark holes and drill hole location.

***NOTE***

Installer shall use a fastener type that will adequately support Branch Box Enclosure

and Branch Box (not included).

If suspending horizontally use all-thread rod through rubber grommet to suspend the

branch box. The installer is responsible for the safe and secure mounting of the

branch box and this enclosure.