Specifications

CNTR-56
CONTROLLER (Feb. 2009)
CONTROLLER
DATA U4
3-10-4. Requirements (system recommendations)
We recommend the following software and hardware when using this application (TG-2000A).
3-10-5. Compatible Units
The TG-2000A has two main functions: centralized control of air conditioners and cost accounting. However, not all
functions are available with all air conditioners. (TG-2000A Ver.4.80 or later)
Computer must be dedicated for this use
(TG-2000A).
Item Requirement Recommended
PC
CPU
Memory
HDD
Storage device
Resolution
Serial port
LAN
OS
Other
Windows XP Professional
Windows 2000 Professional
Service Pack 2 and above
English version only
Personal computer must support each OS.
Internal LAN (10/100 Mbps) 1
1 port or more
Required when using RS-485 communication WHM
1024 768 or higher, 65536 colors or more
FDD, CD-ROM drive Devices other than those shown at the left may also
be installed.
6GB or more (2GB or more of C drive free
space necessary)
4GB or more of C drive free space necessary
128MB or more (In Windows XP : 256MB or more)
512MB or more
Within 1000 indoor units :
Pentium 4 1.8GHz or faster
1001 indoor units or over :
Pentium 4 1.8GHz or faster
(Case of temp, trend use : 2.8GHz or faster.)
Pentium 4 2.8GHz or faster
PC/AT interchangeable machine Operation check completed, using IBM, and DELL
1 Purchase the option, or use the equipment recommended for the personal computer when purchasing the personal computer.
Ta ble: Compatible units and function list ( : supported, : Certain restrictions apply, : Not supported)
Function
Model
Control/
Maintenance
Charging (Billing) with WHM
Y-Series
R2-Series
WR2-Series
WY-Series
S-Series
Indoor unit
LOSSNAY
OA processing unit
"A" control type
"K" control type
1
1
1
1
1
2
4
1
1
1
3
3
(Adapter required)
(Converter required)
1 : Can be calculated for each charging block. May not be available with some older models.
2 : Indoor unit models before Free Plan models do not support a charge apportioning billing method based on
the “capacity save”. The existence of even a single unit of those types in the system requires that the
method of charge apportioning billing be set to either “Thermo on time” or “Fan operation time”.
3 : Not all of the A-control and K-control units support these functions. The calculation of the charge for the
auxiliary heater may not be handled by these units.
4
: LOSSNAY groups to which the remote controller is connected support the charging system.
When using the trend function, the drive used for au-
tomatic output must have the following free space ac-
cording to the number of groups.
200 groups = 2GB, 500 groups = 5GB,
1000 groups = 10GB, 2000 groups = 20GB
3. SYSTEM CONTROLLER