Specifications

CNTR-20

CONTROLLER (Feb. 2009)

CONTROLLER

DATA U4

Cntr- 21

3. System remote controller

DATA U3

CONTROLLER

POWER

GND

12VDC

CN2

CN1

RS232C

Ethernet

ABS

M-NET

NOTE

Perform the LAN wiring before installation, and wire up to the body by the same method as wiring the M-

NET transmission line.

When a LAN is already connected, decide the IP address by consultation with the system administrator and

connect to the LAN body after changing the IP address.

When connecting an LAN connector, space for the connector and wiring is required. Provide this space at

this unit and the rear of the electric box. Refer to Installation Manual.

When the G-50A cover is opened, the LAN status lamp and LAN changeover switch are accessed. For de-

tailed information, refer to Instruction Book.

When using the LAN connection function, connect the LAN cable to the Ethernet connector of this device.

Procure the LAN cable at the site, and use an enhanced category 5 UTP cable.

For a description of the IP address setting method, refer to Installation Manual.

LAN is 10 BASE-T Specification.

3-4-3. LAN connection function

3. SYSTEM CONTROLLER