User`s manual

(56/n)
LEN130391
9. Program Example
9.1 Program Content
This program example is assumed the system configuration in below.
In the program, at first, the parameters of the linked number and station information are set, and the data link with
the parameter of buffer memory startes up.
Next, the reading data shown in below is monitored continuously.
Also, this program is made by using “SW8D5C-GPPW GX Developer”.
Note: The refresh set with the automatic refresh parameters and the refresh executed with the FROM/TO
instructions cannot be performed simultaneously.
9.2 System Configuration
Q series progr
ammable controller
Slot No.0
※Read
ing data
Moniter using monitoring by pattern (P08).
Phase 1 current, Phase 2 current, Phase 3 current,
1-2 voltage, 2-3 voltage, 3-1 voltage,
Total active power, Active energy (import).
Moniter using monitoring by command(1H).
Station number 1:
ME96
Total reactive power, Total power factor,
Rective energy (import lag).
Station number 2:
ME96
Same as above.
Power
Unit
CC-Link
CPU
・・・
Master
Unit
Unit
Station number: 1
ME96
Station number: 2
ME96
Terminal resistor
Terminal resistor
CC-Link dedicated cable