User`s manual

4 - 1
MELSEC-
A
4 SETUP AND PREPARATION BEFORE OPERATION
4 SETUP AND PREPARATION BEFORE OPERATION
4.1 Pre-Operation Procedure
This section explains the preparatory procedure for operating the AJ65SBT-64AD.
START
Create a program.
(When making offset/gain setting, set all
channels to any of user range settings 1 to 3
in the sequence program.)
Start data link.
Make offset/gain setting?
Offset/gain setting (Refer to Section 4.4.)
END
.......Refer to Chapter 5.
No
Yes
4.2 Precautions When Handling
The precautions when handling the AJ65SBT-64AD are described below:
CAUTION
Do not touch any terminal while power is on. Doing so may cause malfunction.
Prevent foreign matter such as dust or wire chips from entering the module.
Such foreign matter can cause a fire, failure, or malfunction.
Do not disassemble or modify the modules.
Doing so may cause failure, malfunction, injury, or a fire.
Do not directly touch any conductive part of the module.
Doing so can cause malfunction or failure of the module.
Do not drop or apply strong shock to the module.
Doing so may damage the module.
Tighten the terminal screw within the specified torque range.
Undertightening can cause short circuit or malfunction.
Overtightening can damage the screw and/or module, resulting in drop, short
circuit, or malfunction.
When disposing of this product, treat it as industrial waste.
4