Installation manual

- 6 -
1. Field-supplied Parts
1 Electric box: PAC-YG83UTB (sold separately) (When following installation method described in section “2. Installation” item
1.)
2 Mounting attachment: PAC-YG81TB (sold separately) (Required only when following installation method described in section
“2. Installation” item 3.)
3 Mounting attachment: PAC-YG85KTB (sold separately) (Required only when following installation method described in
section “2. Installation” item 4.)
4 Locknuts and bushing for the conduit tube.
5 M-NET transmission cable. (Refer to page 8.)
6 DC power cable. (Refer to page 8.)
2. Installation
The controller can be installed by following one of the
methods below:
1 By embedding the centralized controller in the wall and
mounting it to an electric box
An electric box (PAC-YG83UTB; sold separately) is
required.
2 By embedding the centralized controller in the wall
Method of using two plates included with AG-150A.
3 By installing the centralized controller directly on the wall
A mounting attachment (PAC-YG81TB; sold separately)
is required.
4 By installing the centralized controller and a power supply
unit (PAC-SC51KUA; sold separately) inside the
mounting attachment on the wall.
A mounting attachment (PAC-YG85KTB; sold separately)
is required.
6Installation
CAUTION
* Install and wire the unit with the power to the PAC-SC51KUA power supply unit turned off.
* Do not put the signal wire and power wire in the same conduit.
Electric box
(sold separately)
(PAC-YG83UTB)
Wall
AG-150A
AG-150A
Wall
Wall
AG-150A
PAC-YG81TB (sold
separately) is required
mount installations.
Wall
AG-150A
PAC-YG85KTB (sold
separately) is required
in wall mount
installation with both
the controller and a
power supply.
Power supply unit
(PAC-SC51KUA)