User`s manual

Graphic Operation Terminal F930GOT Screen Mode 3
3-2
The functions used in the display example in the previous page can be mainly classified into
four types.
The classified functions have the roles shown below.
(For the details of each function, refer to Sections 9 and 11.)
*1 A part of the data display function can change set values and current values of word devices
(T, C, D, Z and V) on the screen. The operating procedure is described in the next page.
GOT PLC
This function displays the
registered contents in the
specified size in the specified
position.
Characters, external characters,
straight lines, circles, etc.
This function monitors the
contents of devices in the PLC in
the specified size in the specified
position.
The specified area can be
inverted by turning ON/OFF bit
devices in the PLC.
Numerics, bar graphs, indicators,
etc.
*1 The information inside the
PLC is monitored.
Data is transferred to the PLC.
This function turns ON/OFF
specified devices in the PLC and
overwrites the data when a
specified input (operation key,
touch key, etc.) is given.
Touch keys, ten-key pad, etc.
This function sets the
screen to be displayed
next and the screen
changeover condition.
Data display function
Display function
:
:
Data transfer function
:
Screen changeover function
:
OUT
I N
OUT
CPU¥E
PROG¥E
5
4
3
2
1
0
7
6
5
4
3
2
1
0
X7
X6
X5
X4
X3
X2
X1
X0
COM
N
L
Y5
Y4
Y3
Y2
COM2
Y1
COM1
Y0
COM0
COM
24+
RUN
POWER