User`s manual

Graphic Operation Terminal F930GOT Start up 2
2-9
3) Reset of entry code
To reset an entry code and return to the initial setting (in which security is valid), a touch key
should be provided on the screen.
4) Use example
• Suppose that the security level is set in the screen creation software for Screens 1 to 5
shown above.
• In this case, Screen 1 is displayed when the power is turned on (Level 0).
• When an entry code "222" is entered, Screens 1 to 3 can be displayed and manipulated.
• When an entry code "444" is entered while Screens 1 to 3 are displayed, Screens 1 to 5 can
be displayed and manipulated.
• When the entry code is reset while Screens 1 to 5 are displayed, Screen 1 is displayed (ini-
tial status).
* In the use example shown above, the levels and the screen Nos. are consecutive for easy
understanding. The levels and the screen Nos. are not necessarily consecutive.
Example: Screen 1 : Level 3
Screen 2 : Level 7
Screen 3 : Level 5
Screen 10 : Level 2
• The system screens (screen Nos. 1000 and later) are treated as Level 15.
Screen example
Reset of entry code
Touch key
• To set this touch key, enter "FF69"
to the key code.
• The entry code is reset also when
the power of the F930GOT is turned
off. When the power is turned on at
the next time, the security is valid.
• It is recommended to lay out the
entry code input key and the entry
code reset key on the same screen.
Level 2
Entry code:
222
Screen 3
Level 1
Entry code:
111
Screen 2
Level 0
Entry code:
Not provided
Screen 1
Level 3
Entry code:
333
Screen 4
Level 4
Entry code:
444
Screen 5