User`s manual

Graphic Operation Terminal F930GOT Introduction 1

1-29

• Connection diagram

Connect the GOT to the host unit as shown below.

* Control lines RTS, CTS, DTR and DSR are not used.

• Communication setting

The setting related to communication can be performed using the screen creation software

or the GOT main body. (As to the screen creation software, refer to the operation manual of

the software.)

To use general-purpose communication, select "SET-UP MODE", "PLC TYPE" and "UNI-

VERSAL" in this order in the GOT main body.

To set the communication speed (baud rate), the data length, the stop bit length and the

parity, select "SET-UP MODE" and "SERIAL PORT (RS-232C)" in this order in the GOT

main body.

Set each parameter to an either available value shown below.

Table 1.15:

Baud rate 19,200, 9,600, 4,800, 2,400, 1,200, 600 or 300 (bps)

Data length 8 or 7bits

Stop bit length 1 or 2bits

Parity Even, odd or none

Host unit side

➀

➁

➂

➆

➇

➅

➃

➄

GOT

side

D-sub

(female),

9-pin