User`s manual

Graphic Operation Terminal F930GOT Additional Functions (in V.2.00 or later) 13
13-16
13.6.2 Observe status cycle
Set the cycle at which the F930GOT monitors whether the specified triggers are established.
Select "always" or "constant cycle".
-Always:
Every time communication is performed between the F930GOT and the PLC, the
F930GOT monitors whether the specified triggers are established at every 200 to 300 ms.
- Constant cycle: The cycle can be set to 1 to 60 seconds with the increment of 1 second.
At the set cycle, the F930GOT monitors whether the specified triggers are established.
13.6.3 Setting the triggers
Set the triggers to be monitored.
Up to two bit devices can be set.
- Trigger 1: Set ON or OFF of a bit device.
- Trigger 2: Set ON or OFF of a bit device.
• When the trigger 1 and the trigger 2 are set, the F930GOT performs the operation
described in the next paragraph only when the both triggers are established.
• Make sure to set the trigger 1. And set the trigger 2 if necessary.
Example: Trigger 1: "ON" is set.
Trigger 2: "OFF" is set.
Both triggers are established.
ON
OFF
ON
OFF