User`s manual

Graphic Operation Terminal F930GOT Creation of Display Screens (SW
o
oo
o
D5C-GOTRE-PACK) 12
12-8
12.6 Application of screen changeover
This paragraph describes application examples of screen changeover.
12.6.1 Application example 1
In the example below, an abnormality occurs in the machine in the operation mode, an error
message is displayed, then a previous screen is displayed.
Changeover of the base screen
Word device specifying the changeover destination: D0 (initial value)
It is registered as the common setting for all screens.
• When the program shown in the next page is executed while the screen No. 2 or 3 is dis-
played, the screen No. 10 is displayed by the base screen changeover function.
•To return to the previous screen (screen No. 2 or 3) from the
screen No. 10, use the upper hierarchy function of a touch
key.
Setting of the screen No. 10
PREVIOUS key: Upper hierarchy
• When the previous screen is to be displayed, as shown in this example, use the upper hier-
archy function on a touch key.
* MONITOR *
"CYCLE
OPERATION" key
Screen No. 1
ONE CYCLE DRIVEN
Screen No. 2
"CONTINUOUS
OPERATION" key
CONTINUOUS DRIVEN
Screen No. 3
CYCLE
OPERATION
CONTINUOUS
OPERATION
• When the CYCLE OPERATION key is pressed, the screen
No. 2 is displayed. When the CONTINUOUS OPERATION
key is pressed, the screen No. 3 is displayed.
Setting of the screen No. 1
CYCLE OPERATION key : Fixed value = 2
CONTINUOUS OPERATION key: Fixed value = 3
ERROR
Screen No. 10
MOTOR CHECK
" "
To the screen No. 2 or 3