User`s manual

Graphic Operation Terminal F930GOT Introduction 1

1-7

1.5 System configuration

This paragraph describes connection of the GOT to a PLC and peripheral unit.

1.5.1 Enlarged view of connectors

A PLC and peripheral unit can be connected to the following connectors in the GOT.

1) Connectors in the GOT

Connectors are provided on the rear face of the GOT.

➀

PLC connector (RS-422 connector) D-sub, 9-pin, female

This connector allows communication with an FX/A Series PLC.

➁

PC connector (RS-232C connector), D-sub, 9-pin, male

This connector links a personal computer having the screen data created using the screen

creation software to allow data transfer.

When the RS-232C connector in the PC is the 9-pin type, use a data transfer cable FX-

232CAB-1. When the RS-232C connector in the PC is the half-pitch, 14-pin type, use a data

transfer cable FX-232CAB-2.

This connector is used also when the FX

-232-BD is used for an FX

Series PLC or when

1:N connection is adopted with "CPU PORT" in an FX/A Series PLC.

* When a PLC is connected via a computer link unit, use either of the connectors

➀

➁

above.

