User`s manual

Graphic Operation Terminal F930GOT Introduction 1
1-3
1.2 Function list
The functions described in the previous page are divided into four modes shown in table below.
The operator can use each function by selecting a corresponding mode.
Table 1.1:
Mode Function Outline of function
Reference
sections
Remarks
Screen
mode
User screen
display
Character display
• Characters such as alphabets, numbers, Kata-
kana, Kanji and external characters are dis-
played.
• Japanese and English are displayed.
3, 8, 9, 11 Note 1
Graphic display
• Graphics such as straight lines, circles and rect-
angles are displayed.
3, 8, 9, 11
Monitor function
• Set values and current values of word devices (T,
C, D, V and Z) in the PLC can be displayed in the
form of numeric, bar graph, trend graph and
panel meter.
• The color of specified area on the screen is
inverted (between white and blue) in accordance
with the ON/OFF status of bit devices (X, Y, M, S,
T and C) in the PLC.
3, 8, 9, 11
Data change function
• Set values and current values of word devices (T,
C, D, V and Z) in the PLC can be changed in the
form of numeric, bar graph, trend graph and
panel meter.
3, 8, 9, 11
Switch function
• The ON/OFF status of bit devices (X, Y, M, S, T
and C) in the PLC can be controlled in the form
of momentary, alternate and set/reset.
3, 8, 9, 11
Screen changeover
• The display screen can be changed over from
the PLC or a touch key.
3, 10, 12
Recipe function (data file transfer)
• Data saved in the GOT can be transferred to the
PLC.
3, 9, 11
Security function (screen protection function)
• Only screens whose entry code level is equiva-
lent to or lower than the entry code entered by
the operator are displayed. (This function is
available also in the system screens.)
2
Alarm function
• The ON/OFF status of specified bit devices are
monitored, and the number of times of occur-
rence and the occurrence time of alarms are dis-
played. Such alarm data can be saved as alarm
history.
7, 11