User`s manual

Graphic Operation Terminal F930GOT Creation of Display Screens (FX-PCS-DU/WIN-E) 9
9-47
9.5.3 Send Data Bank (recipe function)
The GOT can store up to 4,000 16-bit data corresponding to data registers in the PLC. By giv-
ing a command through a touch key, the data can be read from/written to the PLC. For data
files, refer to "9.6 Data file".
u
uu
u
Contents of setting
1) Bank No.
Enter a file No created using the screen creation software (when selecting "Direct").
Or file No. can be specified using a control device "D0+6" (when selecting "Indirect").
2) Function
Specify the data file transfer direction.
DU
à
PLC: Writes data stored in a data file in the GOT to a data register in the PLC.
PLC
à
DU: Writes data stored in a data register in the PLC to a data file in the GOT.
n
nn
n
Important point
• Data file transfer condition
"
✔
" indicates that transfer is enabled.
Attribute Contents of setting
Control Input Enter a key which actuates data transfer.
Bank No.
Enter a data file No. to be transferred.
Select "Direct" or "Indirect".
Function Select "DU
à
PLC" or "PLC
à
DU".
PLC FX Series A Series
PLC memory type
✔
:RAM
✘
:EPROM *1
✔
:RAM
✔
:EPROM
✘
:EEPROM
*1 When the read/write destination
is a data register, data can be
transferred without regard to the
memory type.
PLC operation status ✔
:RUN
✔
:STOP
✔
:RUN
✔
:STOP
GOT memory type ✔
:Flush memory
✔
:Flush memory
PLC entry code
✘
:While entry
code is regis-
tered (while
write is inhib-
ited)
✔
:While entry
code is
unlocked or is
not registered
✘
:While entry
code is regis-
tered (while
write is inhib-
ited)
✔
:While entry
code is
unlocked or is
not registered