Installation manual

Safety warnings in this manual
In this manual special warnings that are important for the proper and safe use of the products are
clearly identified as follows:
P
DANGER:
Personnel health and injury warnings. Failure to observe the precautions described
here can result in serious health and injury hazards.
E
CAUTION:
Equipment and property damage warnings. Failure to observe the precautions
described here can result in serious damage to the equipment or other property.
General safety information
E
CAUTION:
P
CAUTION:
F920GOT-K / F930GOT-K 5
쎲
Don't mount the graphic operation terminal in an enviroment that contains
dust, soot, conductive or corrosive dusts, corrosive or flammable gas, or
expose the unit to high temperatures, dew condensation or impact and
vibration.
쎲
Make sure to press touch keys on the display screen with the hand only. Don't
use excessive force. Don't use hard or sharp objects such as screw drivers or
pens.
쎲
Don't bind the communication cable together with the main circuit, the power
line or cables containing high voltages or currents.
Keep a distance of at least 100 mm to this cables to prevent malfunction caused
by noise.
쎲
When the communication between the operation terminal and the PLC fails
(e.g. caused by a cable breakage) it is impossible to operate keys or devices in
the PLC via the GOT. After the error is gone the communication will be resu
-
med. Make sure that a switch which gives a significant operation to the system
is executed from any equipment other than the operation terminal and that
there are no adverse consequences in the event of a communication failure .
Emergency stops and other safety functions must not be controlled via the
PLC.
쎲
Switch off the power supply before starting the installation or wiring.