Installation manual

5.2 Connection to a Personal Computer

For the transfer of the user screens to the operation terminal, connect a PC or a notebook com

puter (with the required software installed) to the RS232C port of the GOT.

5.3 Wiring of the Power Supply (F930GOT-K)

Please use wires with a cross section of at least 0,75 mm

for the power supply . Install a fuse of

2 A in the power line.

If the GOT is conected to a PLC of the MELSEC FX series, the service power supply of the PLC

can be used to supply the GOT. Please make sure that the current consumption of all connected

devices such as GOT, extension blocks or special function modules is within the capacity of the

service power supply. If the total current exceeds the capacity of the service power supply, use a

external power supply (24 V DC) to power the GOT.

When the GOT is connected to an external power supply, ground the GOT and the PLC sepa

rately:

Wiring

F920GOT-K / F930GOT-K 21

Anschluss am F920GOT/F930GOT

Cable Length PC side

Port Connector

RS232C 9-pin D-SUB, female FX-232-CAB1 3.0 m 9-pin D-SUB, female

24V

S/S X0 X1 X2 X3 X4 FG

F930GOT--BBD-K-E

24 V DC

MELSEC FX series

24V

S/S X0 X1 X2 X3 X4

24 V DC

F930GOT--BBD-K-E

PLC