Installation manual

4.2 Mounting
The GOT is fixed in the panel with the mounting brackets (four for the F920GOT-K, six for the
F930GOT-K) delivered with the operation panel. Because no holes are needed for these fixings,
they are invisible from the front.
햲
Attach the packing seal to the backside of the GOT.
햴
Hang the hook of the mounting brackets into the slots on the sides of the GOT. Use all sup-
plied mounting brackets to prevent dust and moisture from creeping in.
햵
Tighten the screws of the mounting brackets just enough to fix the GOT.
햶
Check the orientation of the display and the correct mounting of the packing seal.
햷
Now tighten the screws of the mounting brackets until the GOT is securely fixed (tightening
torque: 0.3 to 0.5 Nm).
Installation
F920GOT-K / F930GOT-K 15
MITSUBISHI
F930GOT-BBD-K
MODE
L
SE
R
IAL NO. XXXXXX V.1. 1
1
PROGRAMMABL
E
CONT
R
OL
L
E
R
GRAPHIC OPE
R
AT
I
ON T
E
RMINAL
MIT
S
UBISHI E
L
E
C
T
R
IC CORPORAT
I
ON
COM1
RS232C
COM2
RS422
F930GOT-K F920GOT-K
7
4
1
0
89
5
2
-
6
3
.
ESCSET
DEV
ENT
햳
Insert the GOT from the front of the panel
into the cutout.