Installation manual

4 Installation
The operation terminals of the GOT F900 series are designed to be mounted in a control panel
or the door of a control cabinet.
All mounting angles from 0쎷 (horizontal, e. g. in an control panel) to 90쎷 (vertical, e. g. in a door)
are allowed, but the ambient temperature must kept below 50 쎷C.
4.1 Preparing the Panel Surface
Cut a rectangular mounting hole in the panel surface with the dimensions shown on page 10.
A space of approx. 10 mm is required inside the panel on each side of the cutout for the mounting
brackets. There is no need for drilling additional holes for mounting the GOT. The maximum
thickness of the panel surface is 5 mm.
E
CAUTION:
During mounting of the GOT make sure that no electric wire chips or cutting chips
drop into the ventilation holes of the operating terminal.
Installation
14 MITSUBISHI ELECTRIC
0°
90°
Display
GOT
Control panel etc.