Specifications
Table Of Contents
- 11B ENGINE <6G7 - From 2002>
- GENERAL INFORMATION
- 1. SPECIFICATIONS
- 2. SPECIAL TOOLS
- 3. ALTERNATOR
- 4. CONTROL AND EGR SYSTEM
- 5. INTAKE AND IGNITION SYSTEM
- 6. TIMING BELT
- 7. WATER PIPE AND WATER HOSE
- 8. FUEL SYSTEM
- 9. EXHAUST MANIFOLD
- 10. ROCKER ARMS AND CAMSHAFT
- 11. ROCKER ARMS AND CAMSHAFT
- 12. CYLINDER HEAD AND VALVES
- 13. OIL PAN AND OIL PUMP
- 14. PISTON AND CONNECTING ROD
- 15. CRANKSHAFT, FLYWHEEL AND DRIVE PLATE
- Service bulletins
6G7 ENGINE – Cylinder Head and Valves
11B-12-8
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"DA CYLINDER HEAD BOLT INSTALLATION
1. Fit washers to the cylinder head bolts and install the
bolts in the bolt holes in the cylinder head.
Make sure of the correct orientation of the washer when
installed.
2. Tighten the cylinder head bolts to the specified torque
in the order shown.
3. Loosen all bolts.
4. Tighten the cylinder head bolts to the specified torque
in the order shown.
PWEE9061-I
E
Aug. 2001Mitsubishi Motors Corporation Added
7EN1138
Washer
Cylinder head bolt
Round
shoulder
Cylinder
head
<12-VALVE>
7EN0442
MD998051
<24-VALVE>
MD998051
MD998051
<GDI>
7EN1140
Front (left bank)
Front (right bank)
1
2
37
84
6
5