Specifications

6G7 ENGINE – Rocker Arms and Camshaft <GDI>
11B-11-2
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
REMOVAL SERVICE POINT
AA" LASH ADJUSTER REMOVAL
Caution
If the lash adjuster is re-used, clean the lash adjuster.
(Refer to LASH ADJUSTER INSPECTION)
INSTALLATION SERVICE POINTS
"AA LASH ADJUSTER INSTALLATION
Caution
If the lash adjuster is re-used, clean the lash adjuster.
(Refer to LASH ADJUSTER INSPECTION)
Fit the lash adjuster onto the rocker arm without allowing
diesel fuel to spill out.
"BA BEAM CAMSHAFT CAP, LEFT / BEAM
CAMSHAFT CAP, RIGHT INSTALLATION
1. Remove deposits from the surfaces of the beam camshaft
caps and cylinder head, to which sealant is to be applied.
2. Squeeze a 3-mm-thick bead of sealant from the tube
out into the groove in the bottom surface of the beam
camshaft caps. Fit the caps before the sealant hardens.
Specified sealant:
MITSUBISHI GENUINE Part No. MD970389 or
equivalent
3. Apply an adequate amount of sealant to the top surface
of the cylinder head. Mount the beam bearing caps before
the sealant hardens.
Specified sealant:
MITSUBISHI GENUINE Part No. MD970389 or
equivalent
4. Mount the beam camshaft caps and tighten them in the
order shown to the specified torque.
Specified torque:
M6 bolt: 11"1 Nm
M8 bolt: 24"2 Nm
5. After the caps have been tightened, wipe the portion
of the sealant that is squeezed out at the intake port
before it hardens.
PWEE9061-I
E
Aug. 2001Mitsubishi Motors Corporation Added
7EN1128
3 mm
7EN1204
7EN1129
Front of engine
Note: Same on the left bank
Right bank
11
10
3
1
6
7
2
14
15
18
19
22
23
12
13 17
16
5
4
9
8
21
20