Specifications
Table Of Contents
- 11B ENGINE <6G7 - From 2002>
- GENERAL INFORMATION
- 1. SPECIFICATIONS
- 2. SPECIAL TOOLS
- 3. ALTERNATOR
- 4. CONTROL AND EGR SYSTEM
- 5. INTAKE AND IGNITION SYSTEM
- 6. TIMING BELT
- 7. WATER PIPE AND WATER HOSE
- 8. FUEL SYSTEM
- 9. EXHAUST MANIFOLD
- 10. ROCKER ARMS AND CAMSHAFT
- 11. ROCKER ARMS AND CAMSHAFT
- 12. CYLINDER HEAD AND VALVES
- 13. OIL PAN AND OIL PUMP
- 14. PISTON AND CONNECTING ROD
- 15. CRANKSHAFT, FLYWHEEL AND DRIVE PLATE
- Service bulletins
6G7 ENGINE – Rocker Arms and Camshaft
11B-10-4
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"DA ROCKER ARM SHAFTS INSTALLATION
1. Install the rocker arm shafts “A” and “B” to the camshaft
bearing cap No. 1 and insert the bolts into the holes of
bearing cap and shafts.
2. Install rocker arm shafts with the notched side facing the
bearing cap No. 1 and the oil grooved side facing
downward. The shaft with a smaller oil hole is the rocker
arm shaft “A”.
"EA ROCKER ARMS, ROCKER ARM SHAFTS
INSTALLATION
1. Apply a minimum amount of specified sealant on the four
places of cylinder head.
NOTE
Be sure the sealing agent does not swell out onto the
cam journal surface of the cylinder head. If it swells out,
immediately wipe it off before it can dry.
Specified sealant:
3M NUT Locking No. 4171 or equivalent
2. Install the rocker arms, shafts and bearing caps such that
the arrow mark on the bearing cap faces in the same
direction as the arrow mark on the cylinder head.
PWEE9061-I
E
Aug. 2001Mitsubishi Motors Corporation Added
7EN0587
Notch
on shaft
Rocker arm shaft “B”
Rocker arm
shaft “A”
Cap No.
View P
Oil hole
Rocker arm
shaft “A”
Oil groove
Rocker arm shaft “B”
Bearing cap No. 1
Arrow mark (bearing cap)
Arrow mark (cylinder head)
Arrow mark (bearing cap)
Timing belt side