Specifications
Table Of Contents
- 11B ENGINE <6G7 - From 2002>
- GENERAL INFORMATION
- 1. SPECIFICATIONS
- 2. SPECIAL TOOLS
- 3. ALTERNATOR
- 4. CONTROL AND EGR SYSTEM
- 5. INTAKE AND IGNITION SYSTEM
- 6. TIMING BELT
- 7. WATER PIPE AND WATER HOSE
- 8. FUEL SYSTEM
- 9. EXHAUST MANIFOLD
- 10. ROCKER ARMS AND CAMSHAFT
- 11. ROCKER ARMS AND CAMSHAFT
- 12. CYLINDER HEAD AND VALVES
- 13. OIL PAN AND OIL PUMP
- 14. PISTON AND CONNECTING ROD
- 15. CRANKSHAFT, FLYWHEEL AND DRIVE PLATE
- Service bulletins
6G7 ENGINE – Timing Belt
11B-6-8
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"HA TIMING BELT INSTALLATION
1. Align the timing marks of the camshaft sprockets and
the crankshaft sprocket.
2. First, route the timing belt on the crankshaft sprocket,
then on the camshaft sprocket of the left bank side without
slackness in the tension side.
3. Next, run the timing belt onto the water pump pulley,
the camshaft sprocket on the right bank side, and the
timing belt tensioner.
Tensioner
spring
Timing mark
(on sprocket)
Timing mark
(on alternator bracket)
Timing mark
(on belt cover)
Water pump pulley
Timing mark
(on sprocket)
Camshaft sprocket
Crankshaft sprocket
Timing belt tensioner
Tension side
Camshaft sprocket
Timing mark
(on front case)
Timing mark
(on sprocket)
7EN0007
4. Back off the tensioner lock bolt one or two turns.
5. Install the flange onto the front end of crankshaft.
6. Install the special tool onto the crankshaft.
7. Turn the crankshaft clockwise smoothly two turns.
8. Tighten the tensioner lock nut to specified torque.
PWEE9061-I
E
Aug. 2001Mitsubishi Motors Corporation Added
Lock bolt
MD998716