Specifications

4M41 ENGINE -
Crank Shaft and Crank Case
11B-25-5
"
E
A
REAR OIL SEAL / REAR OIL SEAL CASE
INSTALLATION
(1) Apply a thin coat of engine oil to the lip
A
of the rear
oil seal
11
. Press the rear oil seal all the way into the
rear oil seal case
12
in th e direction shown. Be sure
that the end face
B
of the rear oil seal is flush with the
end face
C
of rear oil seal case.
(2) Apply a 3 mm thick bead of the specified sealant to the
fitting surface of the rear oil seal case
12
.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
Caution
1. Apply the sealant evenly, not broken or
oversupplied.
2. Use care not to let the applied sealant slip out
of place during installation.
"
F
A
FRONT PLATE INSTALLATION
Apply a 2 mm thick bead of the specified sealant to the lower
crankcase assembly
15
and upper crankcase assembly
24
where indicated in the illustration.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
Caution
1. Apply the sealant evenly, not broken or
oversupplied.
2. Use care not to let the applied sealant slip out
of place during installation.
3. The bolt 1 that holds the front plate 2 is also used
to secure the timing gear case. Attach the front
plate with a temporary bolt until the timing gear
case is installed.
PWEE9409-D
E
Feb. 2000Mitsubishi Motors Corporation Added
11
A
B
C
12
15
24