Specifications

4M41 ENGINE -
Oil Cooler and Oil Filter
11B-21-2
CLEANING
(1) Check the oil cooler element
5
for deposited carbon and
sludge in oil passage and bypass, and wash it clean
in cleaning oil, if necessary.
(2) Wash the oil cooler element
5
and the oil cooler body
13
if they are much contaminated with scale.
INSPECTION
OIL COOLER ELEMENT
(1) Immerse the oil cooler element
5
in a water tank, with
the oil outlet
A
closed. Connect a hose to the engine
oil inlet
B
.
(2) Apply an air pressure of 1470 kPa into the oil cooler
element
5
through the connected hose, and check for
air leaks.
(3) Replace the oil cooler element
5
if it leaks.
INSTALLATION SERVICE POINT
"
A
A
OIL FILTER INSTALLATION
(1) Clean the surface of th e oil cooler assembly
2
which
contacts the oil filter
1
.
(2) Apply a thin coat of engine oil to the gasket
A
on the
oil filter
1
.
(3) Holding the gasket
A
in contact with the oil cooler assembly
2
, tighten the cover 5/8 turn.
PWEE9409-D
E
Feb. 2000Mitsubishi Motors Corporation Added
A
B
1
A
2
MH061590