Specifications

4M41 ENGINE -
Timing Gear and Balance Shaft
11B-19-5
"
F
A
BALANCE SHAFT RH ASSEMBLY INSTALLATION
(1) Assemble the parts shown in the illustration to the balance
shaft RH
19.
Be sure to install the washer
14
and thrust spacer
16
in the direction shown in t he illustration, and install the
balance shaft gear RH
15
with its mating mark
“0”
aligned
with the mating mark “
6
” on the oil pump gear
*d
.
A
: Shear droop side
(2) Insert the completed balance shaft RH assembly
12
into
the crankcase assembly while aligning the mating marks
“
5
” on the oil pump gear
*d
and the crankshaft gear
*c
,
and set the shaft assembly in position with the dowel
pin on th e crankcase assembly
*a.
Caution
Insert the balance shaft RH assembly using care not
to damage the inner surface of the balance shaft bush
in the crankcase.
(3) After the timing gears are installed in position, check that
all the rotary parts smoothly rotate.
"
G
A
TIMING CHAIN INSTALLATION
(1) Hold the camshaft sprocket
2
using the special tool.
Component Parts of Special Tool MH063490 - Cam
Sprocket Holder Kit
A
: Nut
B
: Washer
C
: Spacer
D
: Adjusting plate
E
: Nut
G
: Bolt
(2) Check that the match mark “
1
” on the idler gear and
sprocket assembly
42
is in alignment with that on the
crankshaft gear
*c
.
(3) Align the match mark
“0”
on the idler gear and sprocket
assembly
42
with the mark link plate
H
of t he timing
chain
3
.
Caution
The timing chain 3 has the match mark provided at
two places: one bright white link plate H at one place
and a pair of bright white link plates J at the other.
(4) Place the timing chain
3
around the camshaft sprockets
2
while aligning the timing mark
“0”
on the camshaft
sprockets with the mark link plate
J
on the timing chain.
(5) After installing the timing chain
3
, attach the idler washer
41
with the front mark “
F
” facing outward.
PWEE9409-D
E
Feb. 2000Mitsubishi Motors Corporation Added
14
A
16
19
“0”
*d
15
*c
*d
12
*e
“5”
*a
A
B
C
E
D
A
B
2
F
G
2
2
3
42
J
J
“0”
“1”
“0”
H
41
*c
“F”
39