Specifications

4M41 ENGINE -
Timing Gear and Balance Shaft
11B-19-4
"
B
A
IDLER GEAR AND SPROCKET ASSEMBLY
INSTALLATION
Install the idler gear and sprocket assembly
42
onto the idler
shaft
45
while aligning th e mark “
1
” with that on the crankshaft
gear
*c
.
"
C
A
BALANCE SHAFT LH ASSEMBLY INSTALLATION
(1) Assemble the parts shown in the illustration to the balance
shaft LH
38.
Be sure that the washer
31
and thrust spacer
33
face
in correct direction as shown. Install the balance shaft
gear LH
32
with the side showing the match mark
“0”
outward.
A
: Shear droop side
(2) Insert the completed balance shaft LH assembly
29
into
the crankcase assembly
*a
and set it in position with
the dowel pin on the crankcase assembly.
Caution
1. Do not rotate the balance shaft LH assembly 29
during insertion into the crankcase assembly *a.
This may cause the O-ring 35 to be slipped out
of place.
2. Insert the balance shaft LH assembly 29 using
care not to damage the inner surface of the balance
shaft bush in the crankcase.
"
D
A
IDLER GEAR BUSH LH INSTALLATION
Using the special tool, press-fit the idler gear bush LH
25
into the idler gear LH
26
from the side showing the match
marks “
3
” and
“0”
.
"
E
A
IDLER GEAR LH ASSEMBLY INSTALLATION
(1) Install the idler gear LH assembly
24
onto the idler shaft
27
. At this time, be sure to align the match marks “
3
”
and
“0”
on the idler gear with the corresponding match
marks on the idler gear and sprocket assembly
42
and
the balance shaft gear LH
32
.
(2) Then, install the idler washer
23
to the idler gear LH
assembly with its front mark “
F
” facing outward.
PWEE9409-D
E
Feb. 2000Mitsubishi Motors Corporation Added
*c
45
42
“1”
35
31
38
“0”
33
32
A
*a
33
29
“0”
“3”
26
25
MH062463
42
32
27
23
24
“F”
“3”
“0”