Specifications

4M41 ENGINE -
Timing Gear and Balance Shaft
11B-19-3
2. END PLAY
If the reading exceeds the specified service limit, replace
defective part.
Standard value:
Balance shaft LH, RH 0.09 - 0.24 mm
Idler gear and sprocket assembly
0.05 - 0.20 mm
Idler gear LH assembly 0.05 - 0.20 mm
Limit:
Balance shaft LH, RH 0.3 mm
Idler gear and sprocket assembly 0.3 mm
Idler gear LH assembly 0.3 mm
REMOVAL SERVICE POINTS
A
A
"
IDLER GEAR BUSH LH REMOVAL
Using the special tool, remove the idler gear bush
25
.
A
B
"
IDLER SPROCKET BUSH REMOVAL
Using the special tool, remove the idler sprocket bush
43
.
INSTALLATION SERVICE POINTS
"
A
A
IDLER SPROCKET BUSH INSTALLATION
Using the special tool, press-fit the idler sprocket bush
43
into the idler gear and sprocket
42
from the side showing
the match mark
“0”
.
PWEE9409-D
E
Feb. 2000Mitsubishi Motors Corporation Added
MH062463
25
MH062462
43
42
43
“0”
MH062462