Specifications

4M41 ENGINE -
Rocker Cover, Camshaft Holder
Assembly and Camshaft
11B-14-2
Removal steps
1. Oil filler cap
2. Bolt
3. Washer
"
B
A 4. Rocker cover assembly
"
B
A 5. Rocker cover gasket
6. Eyebolt
7. Gasket
8. Eyebolt
9. Gasket
10. Fuel leak-off pipe
11. Bolt
12. Upper guide plate
A
A
""
A
A 13. Bolt
14. Bolt
15. No.1 camshaft cap
16. No.2 camshaft cap
17. No.3 camshaft cap
18. No.4 camshaft cap
19. No.5 camshaft cap
20. Intake camshaft
21. Exhaust camshaft
22. No.1 camshaft holder
23. No.2 camshaft holder
24. No.3 camshaft holder
25. No.4 camshaft holder
26. No.5 camshaft holder
27. Rocker assembly (short)
28. Lock nut
29. Adjusting screw
30. Rocker (short)
31. Rocker assembly (long)
32. Lock nut
33. Adjustng screw
34. Rocker (long)
35. Pivot bolt
Caution
Since the camshaft caps 15 through 19 and camshaft holders 22 through 26 have been machined
in pairs, replacement of either one of the pair is not allowed. Also, never alter their original
combination.
PRE-REMOVAL INSPECTION
CAMSHAFT END PLAY
Measure the end play, and if the reading deviates from t h e
specified value, replace the defective part.
Standard value: 0.10 - 0.18 mm
Limit: 0.3 mm
REMOVAL SERVICE POINT
A
A
"
BOLT REMOVAL
Caution
1. When removing the bolt 13 , be sure to lock the
camshaft 20, 21 by holding the hexagonal part A with
a proper wrench. Do not use the timing chain *b for
the locking.
2. The bolt 13 is inversely threaded. The arrow mark
on its head B indicates its turning direction when
tightened. To remove, turn the bolt in the reverse
direction.
3. The camshaft sprockets *a and timing chain *b must
be meshed in a fixed position. Do not remove the
timing chain from the camshaft sprockets unless
absolutely necessary.
PWEE9409-D
E
Feb. 2000Mitsubishi Motors Corporation Added
13
*b
*a
B