Specifications

4M41 ENGINE -
Turbocharger Assembly
11B-10-2
INSTALLATION SERVICE POINT
"
A
A
TURBOCHARGER ASSEMBLY INSTALLATION
(1) Prior to installing the turbocharger assembly
14
, pour
engine oil into it through the oil inlet hole
A
to lubricate
its component parts for smooth movement.
(2) Using a tester, apply pressure to t he actuator
B
and read
the pressure at which th e rod
C
begins to move
(approximately 1 mm).
If the reading deviates from the specified standard value,
replace the actuator.
Standard value: 161 kP a
Caution
Do not load the actuator B with any more pressure
than 18 1 kPa nor carry the turbocharger by holding
the rod C, or the diaphragm may be damaged.
PWEE9409-D
E
Feb. 2000Mitsubishi Motors Corporation Added
A
B
C