Specifications

4M41 ENGINE -

Cooling Fan, V-belt and Water Pump

11B-5-2

INSPECTION

1. AUTO-COOLING FAN COUPLING

Check th e auto-cooling fan coupling

, and replace if

any of the following conditions exists:

(1) Hydraulic fluid is leaking from the hermetically sealed

housing.

(2) The coupling turns irregularly or produces an

abnormal sound when rotated by hand due to

defective inside bearing.

(3) The coupling has an excessive axial play when moved

with the engine in a cold state.

2. V-BELT

(1) Push the V-belt

at its midpoint with a force of

approximately 98 N as shown and read the amount of

deflection

(2) If the reading deviates from the specified standard value,

accomplish the following adjustment.

(3) Loosen the bolt and nut

holding the generator, and

adjust the tension of the V-belt

using the adjusting

bolt

Caution

1. Be sure to retighten the bolt and nut securely

after the adjustment.

2. Excessive tension damages not only the V-belt

5 itself but bearings elsewhere.

3. Be sure to replace the V-belt 5, when necessary,

in pairs and keep it slush-free.

CLEANING

Remove foreign matters, if any, from the bimetal

using

care not to apply unnecessary force to it.

PWEE9409-D

Feb. 2000Mitsubishi Motors Corporation Added