Specifications

4M41 ENGINE -
Balance Shaft Bush
11B-26-4
(4) Screw the nut
N
onto the installer
K
up to its alignment
mark
P
“-” to predetermine the press-fitting depth of the
balance shaft bush
1
.
(5) Strike on the installer
K
until the nut
N
positively contacts
the washer
M
to press-fit the balance shaft bush
1
into
the crankcase.
(6) Check that the oil hole
Q
,
R
of the balance shaft bush
1
is in alignment with the oil hole
U
in the crankcase.
U
: Oil hole (crankcase)
INSPECTION
BALANCE SHAFT BUSH
Measure the clearance between balance shaft bush
1
and
balance shaft
*b
. If the reading exceeds the specified limit,
replace the defective part(s).
Standard value: 0.06 - 0.11 mm
Limit: 0.16 mm
PWEE9409-D
E
Feb. 2000Mitsubishi Motors Corporation Added
*a
Q, R
U
1
K
N
N
P
N
M
1
1
*b