Service manual

Reelmaster 450–D
Page 6 – 13
Cutting Units
Rev. A
Servicing the Reel Assembly
Disassembly:
1. Remove the guards from each end of the cutting unit
and the front and rear roller assemblies (Fig. 19).
2. Remove the shoulder bolts, bushings and spacers
from each end of the unit and remove the bedbar/bed-
knife assembly (Fig. 20).
3. Remove the inboard locknut from the adjuster pin, the
fasteners for the bracket and remove the adjusting han-
dle assembly from the side plate (Fig. 20).
Figure 19
1. Guard 4. Adjusting assembly
2. Mounting fasteners 5. Dust cap
3. Bedbar mounting assembly
Figure 20
1. Locknut 4. Bearing housing
2. Belleville washer 5. Reel shaft
3. Shoulder bolt 6. Flange bushing