Service manual
Table Of Contents
Specifications
Unit:
mm
(in.)
Item
Standard
Repair
limit
Camshaft
end play
0.05 - 0.112
0.3
(0.00197 - 0.00441)
(0.012)
(b)
Injection pump drive gear
Inspect the gear teeth for damage and also the
mounting bolt holes for malcondition. Replace
the gear
if
found in badly damaged condition.
(c) Crankshaft gear
Replace the gear if its teeth show
signs
of
defective tooth contact, or are excessively worn
or otherwise defective.
(d)
Idler gear
Inspect the idler gear teeth and,
as
necessary,
replace the gear.
(6) Inspect the gear case for cracks, and for evidence
of
oil leakage
at
the part ahead
of
the crankshaft.
A cracked case must be replaced. Inspect the
crank-
shaft pulley, too, examining condition
of
surface
in contact with the oil seal and checking the
keyway and key for wear. Replace the pulley if
found in defective condition.
(1) Reassemble the connecting rod and piston
as
follows:
(a)
Drive
in bushing into connecting rod small end.
The oil holes in bushing and rod must
be
aligned.
REASSEMBLY
-
37-