Product manual

45
352),%860'3#&RPPXQLFDWLRQV#,QWHUIDFH#0#+$7968948334
&RQILJXULQJ#WKH#3/&26&$'$#6XSHUYLVRU
Other than setting the TEC OPTION TYPE and ADDRESS within the Drive, as described
earlier, all configuration is done via the Profibus-DP-Master.
During the start-up phase, the Profibus-DP-Master will check that the Profibus-DP-Slave at the
requested address is of the required type. If it is, Configuration Data and User Parameter Data
are downloaded.
The way the Profibus-DP-Master is configured depends on the manufacturer, but typically the
following steps must be followed as shown in the following diagrams.
1RWH=#
7KH#H[DPSOH#XVHV#6LHPHQV#&20#352),%86#FRQILJXUDWLRQ#WRRO1
next diagram
Start PROFIBUS software
and install / import the supplied
GSD file
Select the Master Station
Type from the list and
click on the OK button
To add a Drive
to the System
click on the
DRIVES button
From the pop-up menu
select the PROFIBUS
Address for the Drive
you are adding to match
the Drive's configured
address and then
click on the OK button
and position the
special cursor
where the Drive
is to be added
Figure 7 Typical Configuration Tool Procedure