Specifications

-48-
HOW TO OPERATE (LCD remote controller PAC-204RC)
If you use the LCD remote controller, you can operate below method.
Please consult operate method with dealer, if you use field supply control parts.
Display section
Before starting operation
1. ON / OFF
Start operation
Stop operation
Operation lamp
B
C
A
H
G
D
E
F
1
E
Warning:
Caution:
J
For purposes of explanation, all the displays on this page
are shown in their lit condition. This configuration does not
occur in the actual unit.
* Make sure that the power supply is turned ON before use.
(Keep the power supply turned ON at all times when the air
conditioner is in use. Use of the unit without power can result
in compressor failure.)
Check and confirm the power circuit before use. For the
contents, refer to
the previously described chapter [Crucial points to be
observed for safety].
[Current/start/ending time] Display
Operation mode
Displays the status of operation.
[Checking] Display
This displays indication when some abnormality occurs in
the unit.
[Set temperature] Display
Displays the set temperature.
[Operation] Lamp
Lights up during operation, goes off during stop.
[Room temperature] Display
Displays the temperature of the air sucked in during
operation.
[Fan] Display
This displays indication fan operation.
[Key lock] Display
This display indication during key lock function active.
[Timer Hold / Resume setting] Display
Press the [ON/OFF] button
Operation lamp lights up and operation starts.
Press the [ON/OFF] button again
Operation lamp goes off and operation stops.
* Once the buttons have been set, pressing of the
[ON/OFF] button only can repeat the same operation
thereafter.
* During operation, the operation lamp above the
[ON/OFF] button lights up.
Even if the operation button is pressed immediately after the
operation is once stopped, operation is not restarted for about
3 minutes.
This function protects the machine. It automatically starts
operation after the lapse of approximately 3 minutes.