Specifications

-45-
2. Caution for use
Keep the following points in mind to safeguard against failures and break downs.
3. Maintenance
Fingermarks
Grease
Neutral
Cleanser
Adhesive
Paste
Isopropyl
alcohol
Heat exchanger
4. The eliminator is installed as before.
Neutral
Cleanser
Shaded
location
Pull out the eliminator
Remove the service panel
Remove the cover
• For safety, confirm that the earth terminal has been connected to the earth wire correctly.
• Never block or cover the unit’s intakes or outlets.
It will reduce the unit’s efficiency.
• To start the unit again after once stopped, be sure to turn the start switch on after 3 minutes elapsed.
Repeating stopping and starting within 3 minutes gives improper force to the machine which can cause to trip the fuse or
power source switch.
For superior performance and lasting durability,
please do not forget to conduct proper and regular
maintenance.
3.1 Cleaning the Eliminator (Field supply)
Clean the eliminator about once a week with a neutral cleanser and leave it to dry in a shady location.
Clean more regularly if the air filter gets very dirty.
If the eliminator gets blocked, air will not be sucked in properly, and the cooling effect will deteriorate.
Failure to clean the eliminator may result in equipment breakdown or malfunctions.
3.2 Cleaning of panel
Clean dirt of panel as follows.
Use a household neutral cleanser such as for dishes or vegetables.
Motion a soft cloth with the cleanser, then wipe lightly.
Next, wipe three or four times with another soft cloth moisten with water.
Finally, wipe off all the remaining cleanser with a soft cloth.
Moisten a soft cloth with the alcohol, then wipe off lightly.
Isopropyl alcohol is sold at stores as regents in small quantities.
(Note)
Alcohol is highly combustible. Take extreme care when handling.
Also, do not use paint or adhesive thinner.
3.3 Cleaning the outdoor Heat Exchanger
If you use your air conditioner for prolonged periods, the outdoor heat exchanger
will become dirty, impairing its function and reducing air conditioners performance.
Note that the stained outdoor heat exchanger may cause the frost to remain during
defrosting.
Consult your equipment supplier or air conditioning contractor on how to clean
the heat exchanger.
3.4 When beginning to use air conditioner again
Please turn on the power supply after confirming an following check is done and abnormality is not found.
Please do the following work.
It is confirmed that air inlet and outlet are not blocked.
It is confirmed that the earth connection line does not come off.
The earth connection line is installed surely in the unit.
It is confirmed that there are neither lifting, blocking, no bending about the drain-hose.
1. It is confirmed to keep the controller OFF.
2. The power supply switch is turned on.
Warning:
1. Do not wash the unit with water.
If washed with water, electrical shock may be caused.
2. Ahead of the maintenance.
For safety, turn the power source off before service work.
1.Removing the eliminator.
The eliminator is mounted in the service
panel.
(In front of the heat exchanger.)
2. The eliminator is cleaned with the cleaner or washed in clear water.
Please wash when dirty is cruel in lukewarm water by which the
neutral detergent is method.
Please do not use a hot water of 50°C or more. (It transforms
occasionally.)
It is necessary to avoid massage washing and squeeze strongly.
It must rinse enough and the detergent must not remain.
3. When the eliminator is washed in clear water, it is often dried because
of shade.
Please do not dry it to direct sunshine and a direct fire.