Specifications

Using programmable controllers Writing programs
2 - 22
 Click the Connection Test button
When properly connected, the connection completion message is displayed.
 Click the OK button.
 Click the OK button.
The connection setting is completed.
Fig. 2-38:
Starting the connection test
000026a
Fig. 2-39:
Connection completion message
000027a
Fig. 2-40:
Click the OK button to close the "Transfer
Setup Connection" screen
000029a
NOTE If the screen shown below is displayed after step  is performed, check that the USB driver has
been installed correctly and that an appropriate connection cable (USB cable) is being used.
For the installation of the USB driver, refer to the GX Works2 installation instructions.
⑩