Installation manual

1) Removing the intake grille

■ PLP-2.5KC

• Slide the levers in the direction indicated by the arrow 1 to open the

intake grille.

• Move the intake grille’s shaft, and it will come off.

A Grille

B Shaft

C Intake grille levers

D Intake grille

■ PLP-2.5KB

• Point the intake grille at the floor, push the button on the grille, and the

intake grille will open slowly. Move the intake grille’s shaft, and it will

come off.

A Grille

B Shaft

C Button

D Intake grille

■ PLP-2.5KC

PUSH

11.3. Installing the grille

s This grille can be installed according to the customer’s request,

for example, facing the grille.

A Refrigerant piping side

B Drainage piping side

C Brand label

1 Standard

2 Change 90° angle

1) Tacking

• Please attach the hook 6 to the unit in advance using the tapping

screw 5, as shown.

• Adjust the position of the grille and place the grille in the unit. Make

sure that the hook will catch the hole on the grille (ø30).

Note:

Check that the connector is not caught in between.

D Unit

E Hook 6

F Tapping screw 3 4 × 10

G Hole (ø30)

H Hole (ø14)

I Screw with captive washer 2

M5 × 0.8 × 25

■ PLP-2.5KB

11. Installing the grille