Specifications

Item Specifications
Operating ambient temperature
✽
1
0 to 55°C
✽
2
Storage ambient temperature -20 to 60°C
Operating ambient humidity 10 to 90% RH, non-condensing
Storage ambient humidity 10 to 90% RH, non-condensing
Vibration resistance
Compliant with
JIS B3502 and
IEC61131-2
Frequency Acceleration Half-amplitude Sweep count
Under intermittent
vibration
5 to 8.4Hz
–
3.5mm
10 times each
in X, Y and Z
directions
8.4 to 150Hz 9.8m/s
2
–
Under continuous
vibration
5 to 8.4Hz
–
1.75mm
–
8.4 to 150Hz 4.9m/s
2
–
Shock resistance Compliant with JIS B3502, IEC 61131-2 (147 m/s2 (15G), 3 times each in X, Y and Z directions)
Operating atmosphere
No oily smoke, corrosive gas or combustible gas, less conductive dust, away from direct sunlight (the same in storage)
Operating altitude
✽
3
2000m or less
Installation location Inside control panel
Overvoltage category
✽
4
II or less
Pollution level
✽
5
2 or less
Cooling method Self-cooling
Grounding Type D grounding (100Ω or less). Connect to panel if unable to ground.
✽1 The operating ambient temperature indicates the temperature
inside the enclosure of the control panel to which the GOT is
installed.
✽2 The maximum operating ambient temperature should be 5°C
lower than that shown in the table on the left when connecting
to a multimedia unit (GT27-MMR-Z), MELSECNET/H
communication unit (GT15-J71LP23-25 or GT15-J71BR13) or
CC-Link communication unit (GT15-J61BT13).
✽3 Do not operate or store the GOT unit in pressurized
environments where the pressure exceeds 0m elevation
atmospheric pressure, as this could result in abnormal operation.
Do not pressurize inside the control panel for air purge cleaning.
The pressure could raise the surface sheet, making the touch
panel difficult to operate or causing the sheet to come off.
✽4 Assuming that the device is connected at some point between a
public power distribution network and local system equipment.
CategoryII applies to devices that are supplied with power from
fixed equipment. The surge withstand voltage is 2,500V for
devices with ratings up to 300V.
✽5 Index that indicates the level of foreign conductive matter in the
operating environment of the device. Pollution level 2 denotes
an environment contaminated only by non-conductive matter
which may, under certain conditions, become temporarily
conductive due to condensation.
Do not use or store the GOT under direct sun light or in
an environment with excessively high temperature, dust,
humidity or vibration.
For inquiries relating to the status of conforming to UL, cUL,
and CE directives and shipping directives, please contact
your local sales office.
General specifications
GT27
Power supply specifications
Item
Specifications
GT2712-STBA
GT2712-STWA
GT2710-STBA
GT2710-VTBA
GT2710-VTWA
GT2708-STBA
GT2708-VTBA
GT2712-STBD
GT2712-STWD
GT2710-STBD
GT2710-VTBD
GT2710-VTWD
GT2708-STBD
GT2708-VTBD
Power supply voltage 100 to 240VAC (+10%, -15%) 24VDC (+25%, -20%)
Power supply frequency 50/60Hz ±5%
–
Power
consumption
Maximum load
44W or less 41W or less
41W or less
45W or less 42W or less 39W or less
Stand alone
19W 17W 15W 18W 15W 13W
Stand alone with backlight off
10W 10W 10W 8W 8W 8W
Inrush current 60A or less (2ms, ambient temperature 25°C, maximum load) 5A or less (20ms, ambient temperature 25°C, maximum load)
Allowable momentary power failure time Within 20ms (100VAC or more) Within 10ms
Noise immunity
Noise voltage 1500Vp-p, noise width 1μs by noise simulator with noise frequency 25 to 60Hz
Noise voltage 500Vp-p, noise width 1μs by noise simulator with noise frequency 25 to 60Hz
Withstand voltage 1500VAC for 1 minute between power supply terminal and ground 350VAC for 1 minute between power supply terminal and ground
Insulation resistance 10MΩ or higher with an insulation resistance tester (500VDC between power supply terminal and ground)
Screen size Model A B Remarks
12.1" GT2712 302 (11.89) 228 (8.98) Same dimensions as GT1685, GT1585, A985GOT.
10.4" GT2710 289 (11.38) 200 (7.87)
Same dimensions as GT167
M, GT157M, A97MGOT.
8.4" GT2708 227 (8.94) 176 (6.93) Same dimensions as GT1665, GT1565.
GT2712 GT2710 GT2708
Unit: mm (inch)
Unit: mm (inch)
A
+2
0
B
+2
0
Panel opening
316 (12.44)
246 (9.69) 227 (8.94)
10
(0.39)
10
(0.39)
52
(2.05)
6
(0.24)
241 (9.49)
241 (9.49)
301 (11.85)
303 (11.93)
208 (8.19)
228 (8.98)
288 (11.34)
218 (8.58)
199 (7.83)
10
(0.39)
10
(0.39)
52
(2.05)
6
(0.24)
241 (9.49)
166 (6.54)
226 (8.90)
171.6
(6.76)
175 (6.89)
194 (7.64)
10
(0.39)
10
(0.39)
52
(2.05)
6
(0.24)
37.5 (1.48)
37.5 (1.48)
Panel cutting dimensions
External dimensions
Graphic Operation Terminal
28
Specifications