Specifications

162
Transducers
Harmonics measurement settings (harmonic voltage, harmonic current)
HARMONIC
%
RMS
<Content (%)> <Effective value>
%
RMS
RMS RMS
<Content (%)>
<
Wait for the test to start > <100% output>
Demand power
time interval
Demand current
time interval
Harmonic demand
voltage/current
time interval
<Effective value>
indication (content (%)) indication (effective value)
indication (content (%)) indication (effective value) 1A✕CT ratio
indication (effective value) 5A✕CT ratio indication (effective value) 3A✕CT ratio
r Continue set up in another setting menu or end set up.
rSetting menu
r Continue set up in another setting menu or end set up.
rSetting menu
r Continue set up in another setting menu or end set up.
rSetting menu
(Refer to of “ Basic settings.”)
iSetting menu
(Refer to of “ Basic settings.”)
iSetting menu
(Refer to of “ Basic settings.”)
iSetting menu
qChange the setting menu to indicate .
RETURN
SET
RETURN
SET
SET
Demand time interval setting (demand power, demand current, harmonic demand voltage/current)
0 seconds
10 seconds
20 seconds
30 seconds
40 seconds
50 seconds
1 minute
2 minutes
3 minutes
4 minutes
5 minutes
6 minutes
7 minutes
8 minutes
9 minutes
10 minutes
15 minutes
20 minutes
25 minutes
30 minutes
RETURN
SET
RETURN SET
SET
Analog output test
Remarks: Refer to “Operation method” on p.158 regarding the method for checking settings.
Wait for the test to start 0% output 50% output 100% output
RETURN SET
RETURN SET
SET
qSetting menu
w
Harmonic voltage
wSet the harmonic voltage measurement pattern.
e
Harmonic current
eSet the harmonic current measurement pattern.
buttons
buttons
buttons
buttons
buttons
buttons
buttons
buttons
buttons
buttons
qSetting menu
qChange the setting menu to indicate .
qSetting menu
qChange the setting menu to indicate .
wSet the demand power time interval.
w Demand power
time interval
e Set the demand current time interval
and the harmonic demand voltage/
current time interval in the same manner
e Perform the analog output
tests for CH2~CH10 in the
same manner
wPerform the analog output CH1 test.
w Analog output
CH1 test
• While waiting for the analog output test to start, the measured value of the set analog output element is
output.
• During analog output testing, output is performed without any relationship to the analog output element
setting.
• After leaving the analog output CH1 test mode, the analog output returns to the ordinary operation state.
• The test mode is for checking the connection of the analog output when there is no input.
• The output during this test cannot be varied by analog output adjustment (zero adjust, span adjust).
DEMAND
TEST