Specifications

151
Transducers
Handling
T-51/T-101 Series
Method for mounting inside panels
Mounting work is to be performed by a person with the proper technological expertise.
 The following four types of mounting can be performed for models with standard
specifications. The mounting parts can be used according to application.
Accessories
Mounting legs are packaged together with the
main unit as accessories.
(1) Using mounting legs
Press-fit
Mounting legs
T-51
T-101
A “mounting leg”
can be removed by
pulling out the leg
while lifting the root
portion of the leg
with a standard
screwdriver.
q
w
(2) Using an IEC 35mm rail
(3) Using a breaker mounting plate for distribution panel
(4) Using a breaker coupling/mounting tabs for distribution panel
(1) Mounting legs (2) IEC 35mm rail
(3)
Breaker mounting plate
for distribution panel
(4) Breaker coupling/mounting
tabs for distribution panel
T-51
T-101
Applicable IEC 35mm rail Mounting Removal
Outer shape of mounting plate Mounting
Outer shape of mounting tabs Mounting
One main unit Two mounting legs
One main unit Four mounting legs
35 27
1
7.3 or more
qLatch on
IEC 35mm rail
wPush in
q
q
Pull down the IEC 35mm rail removal tab
wPull upw
f5.5 mounting holeParting groove
q
w
qLatch on
wPush in
Inserted spring
f4.5 mounting hole (slot)Parting groove
M4 mounting screw
* When mounting using an IEC 35mm rail, affix the unit using a stopper to prevent sliding to the side.
(unit : mm)