Specifications

Bar-shaped Indicators
Mechanical Indicators
103
Terminal
Fastening screw
Fastening screw
(hexagonal bolt with flat groove and 5.5mm opposing sides)
Mounting arm
Mounting arm
Standard screwdriver or box-end screwdriver
Escutcheons
Outer
frame
(In the case of single
unit mounting)
(In the case of
coupled mounting)
Handling precautions
1. Using protective plates
 Protective plates are mounted to indicators so that the gaps
between the indicator and panel cannot be seen. They are
mounted to both sides of an indicator when a single unit is
mounted, and mounted at both ends of the indicator when
coupled mounting is used.
 Plate attachment
Match and insert the upper and lower inner protrusions of
each plate in the grooves of the outer frame at the rear of the
indicator.
 The plates are coated the same color as the outer frame.
 The plates are packaged together with the indicator.
F-213N does not have protective plates.
2. Mounting the indicator
 Push on the front face of the panel to insert the unit. Next, turn the fastening screws in the rear face of the main unit clockwise
using a standard screwdriver or box-end screwdriver with 5.5mm opposing sides. In doing so, the mounting arms will be set
automatically and fixed to the panel (thickness of corresponding panel: 1 to 6mm).
3. Zero-point adjustment
 For indicators other than F-217N, open the tag
number plate using a standard screwdriver and
use the zero-point adjusters inside to adjust the
zero point.
Be careful not to apply excessive force to the
adjusters.
 For zero-point adjustment of the F-217N, use a
standard screwdriver to adjust the zero point by
turning the zero-point adjusters on the front face.
 If the unit is equipped with a zero-suppressed
indicator, perform adjustment while applying
electricity equivalent to the minimum scale value;
for example, 4mA in the case of 4 to 20mA.
Tag number plate
Zero-point adjusters