User`s manual

FX communication
N:N network 4
4-5
4
2 ) In the case of pattern 1 (FX
1N
, FX
2N
, FX
2NC
)
3 ) In the case of pattern 2 (FX
1N
, FX
2N
, FX
2NC
)
4.2.4 Setting Retry Count (D8179)
Set a value 0 to 10 to the special data register D8178. (Default = 3)
This setting is not required for the slave station.
If a master station tries to communicate with the slave station at this retry count (or over),
communication error occur in the station.
4.2.5 Setting Comms Time-out (D8180)
Set value 5 to 255 to the special data register D8179. (Default = 5)
This value multiplied by 10(ms) is duration of the comms time-out.
Comms time-out is the communication dwell time between the master station and slave station.
Station No.
Device No.
Bit device (M) Word device (D)
32 points 4 points
No.0 M1000 to M1031 D0 to D3
No.1 M1064 to M1095 D10 to D13
No.2 M1128 to M1159 D20 to D23
No.3 M1192 to M1223 D30 to D33
No.4 M1256 to M1287 D40 to D43
No.5 M1320 to M1351 D50 to D53
No.6 M1384 to M1415 D60 to D63
No.7 M1448 to M1479 D70 to D73
Station No.
Device No.
Bit device (M) Word device (D)
64 points 8 points
No.0 M1000 to M1063 D0 to D7
No.1 M1064 to M1127 D10 to D17
No.2 M1128 to M1191 D20 to D27
No.3 M1192 to M1255 D30 to D37
No.4 M1256 to M1319 D40 to D47
No.5 M1320 to M1383 D50 to D57
No,6 M1384 to M1447 D60 to D67
No.7 M1448 to M1511 D70 to D77