Programming instructions

112
15.6 Printing
GX-Developer has very flexible printing capabilities. These can be accessed by
clicking on the Printer Icon on the toolbar. The programmer can choose to print
as much or little of the program as required. Some of the available printing
options are:
1. Title – Prints a title page. Title can contain 64 characters/ line at 9
lines. Automatically includes the date of the print out
2. Ladder – Prints the Relay Ladder Logic diagram. Can choose to print
out only part of the program.
3. TC setting – Prints out timer and counter information
4. Device Comments
– Print out any commented devices and the
associated comments
5. List of Used Devices
– Prints out any device that is used in the
program
6. Device Memory – Prints out the contents of the data registers
7. Parameters – Prints out the parameters of the CPU
8. Contact coil used list – Prints out all contacts and coils used in the
program
While each tab can be configured and printed separately, there is an option to
print multiple tabs of data in one print. This is the Multiple Printing button at the
bottom of the window. This window will allow the selection of various tabs of
information to print, as well as the order in which to print each section. Page
numbers will be continuous through the entire printout.
The Page Setup button allows the configuration of the page layout. This includes
margins, header and footer, page numbering, and paper size and orientation.