Programming instructions

104
Find Contact or Coil will search the
program for an address used as either a
contact or a coil. In the first window, select
contact or coil. Then in the right window, enter an address. This can be handy
when an address has been used as a contact numerous times in a program to
find the one location it was used as a coil.
Replace Device allows search and replace
of a device or a range of devices within the
program. A single address can be
specified for the earlier device and for the
new device. The number of substitute
points sets how many consecutive
addresses to move. The check box for
move comments and aliases allows
comments and aliases assigned to an
address to be moved with the address.
The find direction options allow the search
and replace to be restricted to a certain
portion of the program.
Device Block Replacement takes the Replace Device option a step farther. It
allows the programmer to replace multiple ranges of devices in a single
command. Groups of timers, counters, inputs, and data registers can all be
acted on at once. Each line in the chart is a different range of addresses.