Specifications

14
FDUA.FDUM series Inverter Ducted Air Conditioners 2013
Hyper Inverter Outdoor Unit.
5.0~16.0kW.
FDC71VNX
Installation workability
Enhanced installation workability thanks to the extended pipe length – one of the longest
levels in the industry. Units are pre-charged with refrigerant.
Refrigerant precharged piping length extends up to 30m. (5.0 & 6.0kW up to 15m)
This eliminates the need to add refrigerant on site, which sets it free from the trouble of
excessive or insufcient charging of refrigerant and allows carrying out the installation
smoothly.
Piping length–100m
(Hyper Inverter 12.5~14.0kW)
Refrigerant precharged piping length extending to 30m
FDC125VNX
FDC140VNX
FDC160VSX
SRC50ZJX-S
SRC60ZJX-S
Due to application of blue coated ns
(KS101) for the heat exchanger of the new
outdoor unit, corrosion resistance has been
improved compared to previous models.
Blue Fin 7.1-14.0kW
Blue
Fin
Blue
Fin
This kit is recommended to be used in an area where the
temperature drops below 0˚C.
Base heater kit (option)
CW-H-E
applied for FDC100VN
FDC125~140VNX
Height difference
(Outdoor higher than Indoor)
Piping
length
Micro Inverter
kW
5~6
7.1
12.5~14
16
30m
50m
100m
70m
20m
30m
30m
30m
Piping
length
Height
difference
Height difference
(Outdoor higher than Indoor)
Piping
length
kW
10 50m 30m
Piping
length
Height
difference
FDC100VN
Micro
Pressure caused by air ow in the indoor unit
is reduced by making the air outlet larger.
The reduction of pressure reduces the load
on the fan motor so efciency increases.
Reduction of air ow pressure loss Increase of heat transfer efciency
Heat transfer efciency has improved by using
high efciency piping and by the redesign of the
heat exchanger from 2 to 1 piece.
All models of the FD inverter series use
refrigerant R410A characterized by the
ozone depletion coefcient being 0.
In order to comply with RoHS standard, the new inverter
series use lead free solder.
*"RoHS" is the abbreviation of the new European standard, which
means Restriction of Hazardous Substances.
Employment of lead free solder Employment of refrigerant
Adapt to RoHS
High efciency
Convenience
All models employ R410A with RoHS* directive
CnT terminal
A dry contact is tted to each indoor
unit which is used when a signal
output is required.
XR5
CnT
XR1~5 : approx. DC12v
XR3
XR1
XR2
XR4
XR5
XR1
XR2
XR3
XR4
output1 (run)
output2 (heat)
output3 (comp on)
output4 (alarm)
common
Power source
in put
The new remote control for all indoor units.
Non-polar 2 core wiring is used. Installation
is easier.
Remote control RC-E5
Condensers are tted with RS232C so you
can connect directly to your PC for monitoring.
MHI service software, Mente PC makes
service tasks simple.
Monitoring Function
Previous
Current
3-core
2-core2-core