User manual

3 - 64 3 - 64
MELSEC-Q
3 SPECIFICATIONS
(3) System switching when the link cable disconnection occurs in the
host network module
If a communication error occurs due to link cable disconnection on the host
network module, it will considerably increase "data link monitoring time +
switching monitoring time".
Therefore, the calculation formula is not affected by the CPU system switching
time and the switching time from the multiplexed remote master station to the
multiplexed remote sub-master station.
Mult iplexed remot e mast er st at ion
Cont rol syst em st andby syst em
Multiplexed remote sub- master station
St andby syst em cont rol syst em
Remote I/O station
(
R
)
Remote I/O station
(
R
)
Remote I/O station
(
R
)
Network
Standby system control system CPU
An error has occurred on the control system
SS
500
K
Tsw
Scan
Control system standby system CPU
Output holding time of remote I/O station
Toh
Tc
[Output holding time (Toh)]
Toh = 500 + K + Tc + Tsw + (SS 2) [ms]
K: Data link monitoring time (set up by the common parameters in the network
parameters) [ms]
Tc: Switching monitoring time (specify the setting range using SW0018)
10ms [ms]
Tsw: Redundant CPU system switching time [ms]
SS: Scanning time of the redundant CPU [ms]
POINT
For the CPU system switching time, refer to QnPRHCPU User's Manual
(Redundant System).